Alan Kirkup's Blog (3)

Visual Effects of the UV Steriliser

I attached a sheet of A4 gloss photo paper to the cupboard door beside my tank

so looking down the length of the tank it gives a good indication of water clarity

(photo's taken in same exposure mode and lighting conditions *room…

Continue

Added by Alan Kirkup on March 23, 2013 at 5:00am — 3 Comments

New sand and Gravel, + Filter improvements...maybe!

I just love spending ages pouring loads of water over new gravel or in this case sand to get it as clean as possible for my beloved aquarium, perhaps just a tad of sarcasm in that part of my blog post. Anyway onto the filter, I don't know if I've caused any potential issues but I've just removed the "check ball" from the intake strainer of my fluval 206 external, and all that seems to have happened is the outflow speed has increased quite a bit for doing so, had a little ponder and during my…

Continue

Added by Alan Kirkup on March 16, 2013 at 4:00pm — 2 Comments

UV Steriliser

I've just purchased an in-line Vecton V2 UV 300 Aquarium Steriliser, and my question to you is which of the hoses on my filter should it be installed, the one from the intake or the one to the outflow. There is nothing that I can see in the manual informing of which it should be. Perhaps it…

Continue

Added by Alan Kirkup on March 12, 2013 at 6:19pm — 7 Comments

               

Blog Posts

Posted by Richard on December 29, 2019 at 10:59pm 0 Comments

10 Gallon planted Guppy

Posted by Richard on December 29, 2019 at 10:58pm 0 Comments

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

Birthdays

Birthdays Today

© 2024   Created by Dustin Wunderlich.   Powered by

Badges  |  Report an Issue  |  Terms of Service